PIC16C711-20/SO【PDF 29/177 页】IC MCU OTP 1KX14 A/D 18SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3861

25页 26页 27页 28页 [29页]30页 31页 32页 33页

124

7593L–AVR–09/12

AT90USB64/128

Using the Input Capture unit in any mode of operation when the TOP value (resolution) is

actively changed during operation, is not recommended.

Measurement of an external signal’s duty cycle requires that the trigger edge is changed after

each capture. Changing the edge sensing must be done as early as possible after the ICRn

cleared by software (writing a logical one to the I/O bit location). For measuring frequency only,

the clearing of the ICFn Flag is not required (if an interrupt handler is used).

15.6

Output Compare units

The 16-bit comparator continuously compares TCNTn with the Output Compare Register

(OCRnx). If TCNT equals OCRnx the comparator signals a match. A match will set the Output

Compare Flag (OCFnx) at the next timer clock cycle. If enabled (OCIEnx = 1), the Output Com-

pare Flag generates an Output Compare interrupt. The OCFnx Flag is automatically cleared

when the interrupt is executed. Alternatively the OCFnx Flag can be cleared by software by writ-

ing a logical one to its I/O bit location. The Waveform Generator uses the match signal to

generate an output according to operating mode set by the Waveform Generation mode

(WGMn3:0) bits and Compare Output mode (COMnx1:0) bits. The TOP and BOTTOM signals

are used by the Waveform Generator for handling the special cases of the extreme values in

some modes of operation (see “Modes of operation” on page 127)

A special feature of Output Compare unit A allows it to define the Timer/Counter TOP value (that

is, counter resolution). In addition to the counter resolution, the TOP value defines the period

time for waveforms generated by the Waveform Generator.

Figure 15-4 shows a block diagram of the Output Compare unit. The small “n” in the register and

bit names indicates the device number (n = n for Timer/Counter n), and the “x” indicates Output

Compare unit (A/B/C). The elements of the block diagram that are not directly a part of the Out-

put Compare unit are gray shaded.

Figure 15-4. Output Compare Unit, block diagram.

OCFnx (int.req.)

= (16-bit comparator )

OCRnx buffer (16-bit register)

OCRnxH buf. (8-bit)

OCnx

TEMP (8-bit)

DATA BUS (8-bit)

OCRnxL buf. (8-bit)

TCNTn (16-bit counter)

TCNTnH (8-bit)

TCNTnL (8-bit)

COMnx1:0

WGMn3:0

OCRnx (16-bit register)

OCRnxH (8-bit)

OCRnxL (8-bit)

Waveform generator

TOP

BOTTOM

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式